LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 2002 (Hybrid Cooling System - 3.6L (Hp5)) >> Repair Instructions >> Generator Control Module Coolant Pump Hose Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Generator Control Module Coolant Pump Hose
    GM2159160Courtesy of GENERAL MOTORS CORP.
  1. Install the generator control module coolant pump hose (3) to the vehicle.
  2. Install the generator control module coolant pump hose fastener (2) to the cooling fan shroud.
  3. Install the generator control module coolant pump hose (3) to the drive motor generator control module coolant pump.
  4. Using J 38185:  Hose Clamp Pliers reposition the generator control module coolant pump hose clamp (1).
  5. Install the coolant recovery reservoir. Refer to Coolant Recovery Reservoir Replacement (HP5)
  6. Install the underhood junction block. Refer to Underhood Electrical Center or Junction Block Replacement (HP5)
    7. Fig 2: Surge Tank Outlet Hose
    GM2142903Courtesy of GENERAL MOTORS CORP.
  7. Install the generator control module coolant pump hose (2) to the radiator surge tank air separator.
  8. Using J 38185:  Hose Clamp Pliers reposition the generator control module coolant pump hose clamp (1).
  9. Install the left headlamp. Refer to Headlamp Replacement
  10. Fill the generator control module cooling system. Refer to Generator Control Module Cooling System Draining and Filling 
scientia non olet · About LEMON Manuals