LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 2002 (Hybrid Cooling System - 3.6L (Hp5)) >> Repair Instructions >> Generator Control Module Coolant Inlet Hose Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the generator control module cooling system. Refer to Generator Control Module Cooling System Draining and Filling 
  2. Remove the drive motor power inverter module bracket. Refer to Generator Control Module Bracket Replacement
  3. Remove the left headlamp. Refer to Headlamp Replacement
  4. Remove the radiator opening upper cover. Refer to Radiator Opening Upper Cover Replacement
    5. Fig 1: Generator Control Module Coolant Inlet Hose Quick Connect Fitting & Coolant Inlet Hose
    GM2152475Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the generator control module coolant inlet hose quick connect fitting (1).
  6. Remove the generator control module coolant inlet hose (2) from the generator control module.
    7. Fig 2: Generator Control Module Coolant Inlet Hose
    GM2152484Courtesy of GENERAL MOTORS CORP.
  7. Using J 38185:  Hose Clamp Pliers reposition the generator control module coolant inlet hose clamp (1).
  8. Remove the generator control module coolant inlet hose (2) from the radiator.
  9. Remove the generator control module coolant inlet hose from the vehicle.
scientia non olet · About LEMON Manuals