LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1969 (Transfer Case - GETRAG 760) >> Repair Instructions - Off Vehicle >> Transfer Case Disassemble >> Rear Output Shaft Housing Disassembly

Rear Output Shaft Housing Disassembly

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Exploded View Of Rear Output Shaft Housing
GM1708633Courtesy of GENERAL MOTORS CORP.
Rear Output Shaft Housing Disassembly

Callout Component Name
1 Transfer Case Rear Output Drive Gear Nut
Tip:  Use a 30 mm socket or J 29873  .
Special Tools: 
J-08614-A  Pinion Flange Holder and Remover. See Special Tools .
2 Transfer Case Rear Output Shaft Flange
Special Tools: 
DT-48146  Press Support. See Special Tools .
3 Transfer Case Rear Output Shaft Bearing Assembly
Tip:  Use a press to remove the output shaft from the housing.
4 Transfer Case Rear Output Shaft Bearing Spacer
5 Transfer Case Rear Output Shaft
6 Transfer Case Rear Output Shaft Oil Slinger
Tip:  Remove the slinger only if damaged.
Refer to Rear Output Drive Housing Cleaning and Inspection .
7 Transfer Case Rear Output Shaft Seal
Tip:  Discard the seal after removal.
scientia non olet · About LEMON Manuals