LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1966 (Engine Controls And Fuel - 3.6L (LCS) - Introduction) >> Repair Instructions >> Fuel Feed Intermediate Pipe Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the drive motor generator power inverter module. Refer to Drive Motor Generator Power Inverter Module Removal and Installation .
  2. Remove the high pressure pump shield. Refer to Fuel Pipe Shield Replacement .
  3. Relieve fuel system pressure. Refer to Fuel Pressure Relief (with CH 48027-100) or Fuel Pressure Relief (w/o CH 48027-100) .
    4. Fig 1: Identifying High Pressure Pipe Fitting, Left Fuel Rail & High Pressure Fuel Pipe
    GM1977757Courtesy of GENERAL MOTORS CORP.
  4. Remove the foam insulator from the pipes.
  5. Loosen the high pressure pipe fitting to the high pressure fuel pump (1).
  6. Loosen the high pressure pipe fitting to the left fuel rail (3).
  7. Remove the high pressure fuel pipe (2) from the vehicle. Discard the pipe.
scientia non olet · About LEMON Manuals