LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1966 (Engine Controls And Fuel - 3.6L (LCS) - Introduction) >> Repair Instructions >> Filler Tube Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Fuel Tank Fill Pipe Screws
    GM1885419Courtesy of GENERAL MOTORS CORP.
  1. Drain the fuel tank until the level in the tank is less than 1/4 full. Refer to Fuel Tank Draining .
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  3. Remove the fuel fill cap.
  4. Remove the fuel tank fill pipe housing to fuel tank fill pipe screws (1).
    5. Fig 2: Fuel Fill Pipe Upper Bracket Nut
    GM1885420Courtesy of GENERAL MOTORS CORP.
  5. Remove the right rear wheelhouse liner. Refer to Rear Wheelhouse Panel Liner Replacement .
  6. Remove the fuel fill pipe upper bracket nut (1).
    7. Fig 3: Fill Pipe Vent Line Quick Connect Fitting
    GM1884596Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the fill pipe vent line quick connect fitting (4) from the fuel tank fresh air line (3). Refer to Plastic Collar Quick Connect Fitting Service .
  8. Disconnect the fuel tank vapor line quick connect fitting (2) from the fill pipe recirculation line (5). Refer to Plastic Collar Quick Connect Fitting Service .
  9. Loosen the fuel fill pipe hose clamp (1) at the fuel tank.
  10. Remove the fuel fill pipe (6) from the fuel tank.
scientia non olet · About LEMON Manuals