LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1929 (Engine Mechanical - 3.6L (2 Of 6)) >> Repair Instructions - On Vehicle (1 Of 2) >> Oil Level Indicator Tube Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Oil Level Indicator Tube & Bolt
    GM1829621Courtesy of GENERAL MOTORS CORP.
  1. Turn the ignition OFF.
  2. Remove the oil level indicator from the oil level indicator tube.
  3. If equipped with LCS Remove the underhood fuse block and bracket. refer to Underhood Electrical Center or Junction Block Replacement (HP7) or Underhood Electrical Center or Junction Block Replacement (HP5)
  4. Remove the oil level indicator tube bolt.
  5. Remove the oil level indicator tube up through the exhaust manifold.
  6. If replacing only the oil level indicator tube seal, remove and discard the old seal.
scientia non olet · About LEMON Manuals