LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1929 (Engine Mechanical - 3.6L (2 Of 6)) >> Repair Instructions - On Vehicle (1 Of 2) >> Crankshaft Balancer Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Tool EN 46106
    GM945978Courtesy of GENERAL MOTORS CORP.
  1. The EN 46106  must be installed onto the flywheel. See Special Tools .
  2. Use the J 41998-B  , nut, bearing and washer to install the crankshaft balancer. See Special Tools .
    3. Fig 2: Identifying Lubrication & Non-Lubrication Areas On Crankshaft Balancer
    GM1395952Courtesy of GENERAL MOTORS CORP.
    NOTE: Do not lubricate the crankshaft front oil seal or crankshaft balancer sealing surfaces. The crankshaft balancer is installed into a dry seal.
  3. Apply lubricant to the inside of the crankshaft balancer hub bore.
    4. Fig 3: Installing Crankshaft Balancer Using J 41998-B
    GM1395954Courtesy of GENERAL MOTORS CORP.
  4. Place the crankshaft balancer in position on the crankshaft.
  5. Thread the J 41998-B  in the crankshaft. See Special Tools . Ensure you engage at least 10 threads of the J 41998-B  before pressing the crankshaft balancer in place. See Special Tools .
  6. Push the crankshaft balancer into position by tightening the nut on the J 41998-B  until the large washer bottoms out on the crankshaft end. See Special Tools .
  7. Remove the J 41998-B  . See Special Tools .
    8. Fig 4: Identifying Crankshaft Balancer Bolt
    GM1395946Courtesy of GENERAL MOTORS CORP.
  8. Install the crankshaft balancer bolt.
    9. CAUTION: Refer to Fastener Caution .
  9. Tighten the crankshaft balancer bolt.
    • Tighten the crankshaft balancer bolt to 100 N.m (74 lb ft).
    • Tighten the crankshaft balancer bolt an additional 150 degrees using the J 45059  .
    10. Fig 5: View Of Tool EN 46106
    GM945978Courtesy of GENERAL MOTORS CORP.
  10. Install the splash shield. Refer to Engine Splash Shield Replacement .
  11. Remove the EN 46106  . See Special Tools .
  12. Install the starter. Refer to Starter Replacement (LY7) .
  13. Using engine support fixture, raise the engine into position.
  14. Install the drive belt. Refer to Drive Belt Replacement (LY7)  or Drive Belt Replacement (LCS) .
scientia non olet · About LEMON Manuals