LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1926 (Power Steering System) >> Repair Instructions >> Steering Gear Boot Replacement - Off Vehicle >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering gear. Refer to Steering Gear Replacement (HP5)  or Steering Gear Replacement (NJ1 or HP7)  or Steering Gear Replacement (NVH) .
    2. NOTE: Count the total number of complete rotations needed to remove the steering linkage outer tie rod from the steering linkage inner tie rod.
  2. Remove the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement .
  3. Remove the steering linkage inner tie rod nut.
  4. Remove the steering gear boot clamps and discard them.
    5. Fig 1: View Of Inner Tie Rod & Boot
    GM925777Courtesy of GENERAL MOTORS CORP.
  5. Remove the steering gear boot.
  6. Clean the steering linkage inner tie rod and steering gear boot contact area of any grease and debris.
scientia non olet · About LEMON Manuals