LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1926 (Power Steering System) >> Repair Instructions >> Power Steering Pump Replacement (LY7) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the power steering pump to the vehicle through the right wheelhouse area.
    2. Fig 1: Identifying Power Steering Pump Bolts
    GM1818216Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
    NOTE: Hand start both bolts before finalizing any torques.
  2. Install the power steering pump bolts (1) and tighten to 50 N.m (37 lb ft).
    3. Fig 2: Identifying Power Steering Gear Inlet Hose
    GM1818210Courtesy of GENERAL MOTORS CORP.
  3. Connect the power steering gear inlet hose (1) to the power steering pump.

    Tighten the fitting to 25 N.m (18 lb ft).

    4. Fig 3: Identifying Power Steering Reservoir Outlet Hose & Clamp
    GM1818200Courtesy of GENERAL MOTORS CORP.
  4. Compress the power steering reservoir outlet hose clamp (1) and connect the power steering reservoir outlet hose (2) to the power steering pump.
  5. Clean any excess fluid from the vehicle and remove the drain pans.
  6. Install the right front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
  7. Install the drive belt. Refer to Drive Belt Replacement (LY7) or Drive Belt Replacement (LCS) .
  8. Fill and bleed the power steering system. Refer to Power Steering System Bleeding .
scientia non olet · About LEMON Manuals