Installation Procedure
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Position the battery positive and negative cable to the vehicle.
- Install the positive cable to the starter solenoid BAT stud and install the starter solenoid BAT terminal nut (1).
Tighten the nut to 15 N.m (11 lb ft).
- Lower the vehicle.
- Install the positive cable to the junction block and install the positive cable junction block nut (1).
Tighten the nut to 15 N.m (11 lb ft).
- Install the negative cable ground and engine wiring harness ground bolt (1) at the rear of the right side cylinder head.
Tighten the bolt to 25 N.m (18 lb ft).
- Install the negative cable ground to the body ground stud and install the negative cable ground nut (1).
Tighten the nut to 10 N.m (89 lb in).
- Install the positive cable to the battery and install the positive cable nut (3).
Tighten the nut to 5 N.m (45 lb in).
- Install the negative cable to the battery. Refer to Battery Negative Cable Disconnection and Connection .
- Install the battery cover (1) until the battery cover retaining tabs (2) lock into place.
- Position the ECM bracket in place. Refer to Engine Control Module Replacement .
- Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
NOTE:
Route the battery positive and negative cable the same way as originally installed.
CAUTION:
Refer to Fastener Caution
.