LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1910 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Rear Side Door Adjustment

Rear Side Door Adjustment

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Rear Door
    GM1413125Courtesy of GENERAL MOTORS CORP.
    WARNING: In order to prevent SIR deployment, personal injury, or unnecessary SIR system repairs, do not strike the door or the door pillar in the area of the side impact sensor (SIS). Turn OFF the ignition and remove the key when performing service in the area of the SIS.
  1. Remove the door striker. Refer to Rear Side Door Lock Striker Replacement .
  2. For up, down, forward, or rearward adjustment, loosen the hinge to hinge pillar bolts.
  3. Move the door within the door opening to achieve the best alignment and operation.
  4. CAUTION: Refer to Fastener Caution .
  5. Tighten all of the hinge fasteners that were loosened.

    Tighten:  Tighten the hinge fasteners to 25 N.m (18 lb ft).

  6. Install the striker to the approximate proper position.
  7. Adjust the door striker. Refer to Rear Side Door Lock Striker Adjustment .
  8. Inspect the door weatherstrips for proper fit.