Air Conditioning (A/C) Diagnostics - Pressure Zone D (without HP5)

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Step	Action	Yes	No
DEFINITION: The low side pressure is lower than normal and the high side pressure is higher than normal. A restriction in the Air Conditioning (A/C) system Debris in the system
1	Were you sent here from the air conditioning (A/C) System Performance Test?	Go to Step 2	Go to Air Conditioning (A/C) System Performance Test (LY7) or Air Conditioning (A/C) System Performance Test (LZ4) or Air Conditioning (A/C) System Performance Test (LE5) or Air Conditioning (A/C) System Performance Test (LY7 Red Line) or Air Conditioning (A/C) System Performance Test (LAT Green Line) or Air Conditioning (A/C) System Performance Test (HP5)
2	CAUTION: Refer to Moving Parts and Hot Surfaces Warning . Feel the liquid line before the thermal expansion valve (TXV).Is the liquid line cold before the TXV?	Go to Step 3	Go to Step 8
3	Feel along the surfaces of the following high side components: The compressor hose between the compressor and the condenser The condenser The liquid line between the condenser and the TXV Did you detect an abrupt drop in temperature along the surfaces of any of the listed components?	Go to Step 7	Go to Step 4
4	Feel the liquid line at the TXV location for extreme cold, possibly accompanied by heavy frost. Feel along the liquid line beyond the TXV location for warm temperature. Is the liquid line extremely cold at the TXV location and warm beyond the TXV location?	Go to Step 11	Go to Step 5
5	Feel along the surfaces of the following low side components: The evaporator inlet tube between the TXV and the evaporator core The evaporator outlet tube between the evaporator core and the compressor suction hose The compressor suction hose Did you feel an abrupt temperature change along the surfaces of any of the listed components?	Go to Step 7	Go to Step 6
6	Feel along the surfaces of the low and the high side components. The evaporator inlet tube between the TXV and the evaporator core The evaporator outlet hose between the TXV and the compressor The compressor hose assembly The condenser The liquid line between the condenser and the TXV Are the temperatures of these components only mildly warm?	Go to Step 14	Go to Step 8
7	Recover the refrigerant. Refer to Refrigerant Recovery and Recharging (With HP5) or Refrigerant Recovery and Recharging (Without HP5) . Remove the restriction from the component, or replace the component which produced an abrupt temperature drop. Is the action complete?	Go to Step 9	-
8	Recover the refrigerant and evacuate the system. Refer to Refrigerant Recovery and Recharging (With HP5) or Refrigerant Recovery and Recharging (Without HP5) . Record the weight of the recovered refrigerant. Compare the weight of the recovered refrigerant with the system capacity. Refer to Refrigerant System Capacities (With HP5) or Refrigerant System Capacities (Without HP5) . Is the weight of the recovered refrigerant charge greater than 75 percent of the total system capacity?	Go to Step 9	Go to Step 10
9	Recharge the A/C system. Refer to Refrigerant Recovery and Recharging (With HP5) or Refrigerant Recovery and Recharging (Without HP5) . Is the cooling performance improved?	Go to Step 20	Go to Step 10
10	Leak test the system. Refer to Leak Testing (With HP5) or Leak Testing (Without HP5) . Repair any leaks. Is the action complete?	Go to Step 20	-
11	The TXV is restricted. Replace the TXV. Refer to Air Conditioning Evaporator Thermal Expansion Valve Replacement . If the TXV was restricted, note the type of debris present. Are metal flakes present?	Go to Step 12	Go to Step 13
12	Remove the compressor hose assembly from the vehicle. Refer to Air Conditioning Compressor Hose Replacement (LZ4) or Air Conditioning Compressor Hose Replacement (LAT) or Air Conditioning Compressor Hose Replacement (LY7) or Air Conditioning Compressor Hose Replacement (LE5) . Inspect the hose for debris by blowing shop air through one end of the hose while covering the other end with a shop towel. Observe the amount of debris collected in the shop towel. Did a large amount of debris collect in the shop towel?	Go to Step 18	Go to Step 19
13	If the TXV was restricted with a brown or black residue, replace the refrigerant desiccant. Refer to Air Conditioning Refrigerant Desiccant Replacement . Are the actions complete?	Go to Step 20	-
14	Recover the refrigerant. Refer to Refrigerant Recovery and Recharging (With HP5) or Refrigerant Recovery and Recharging (Without HP5) . Disconnect the compressor hose from the compressor. Refer to Air Conditioning Compressor Hose Replacement (LZ4) or Air Conditioning Compressor Hose Replacement (LAT) or Air Conditioning Compressor Hose Replacement (LY7) or Air Conditioning Compressor Hose Replacement (LE5) . Inspect for the presence of debris in the compressor suction port. Is debris present in the compressor suction port?	Go to Step 15	Go to Step 19
15	Remove the debris from the suction port. Inspect the TXV for damage or debris. Refer to Air Conditioning Evaporator Thermal Expansion Valve Replacement . Did you find evidence of damage or debris?	Go to Step 17	Go to Step 16
16	If the TXV does not show any signs of damage or debris, perform the following procedure: Remove the compressor hose assembly from the vehicle. Refer to Air Conditioning Compressor Hose Replacement (LZ4) or Air Conditioning Compressor Hose Replacement (LAT) or Air Conditioning Compressor Hose Replacement (LY7) or Air Conditioning Compressor Hose Replacement (LE5) . Inspect the hose for debris by blowing shop air through one end of the hose while covering the other end with a shop towel. Observe the amount of debris collected in the shop towel. Did a large amount of debris collect in the shop towel?	Go to Step 18	Go to Step 19
17	Replace the TXV. Refer to Air Conditioning Evaporator Thermal Expansion Valve Replacement . If the TXV was restricted, observe the type of debris present. Are metal flakes present?	Go to Step 12	Go to Step 13
18	If a large amount of debris was collected in the shop towel from the compressor hose assembly, replace the refrigerant desiccant. Refer to Air Conditioning Refrigerant Desiccant Replacement . Is the action complete?	Go to Step 19	-
19	Install the compressor hose assembly. Refer to Air Conditioning Compressor Hose Replacement (LZ4) or Air Conditioning Compressor Hose Replacement (LAT) or Air Conditioning Compressor Hose Replacement (LY7) or Air Conditioning Compressor Hose Replacement (LE5) . Recharge the A/C system. Refer to Refrigerant Recovery and Recharging (With HP5) or Refrigerant Recovery and Recharging (Without HP5) . Are the actions complete?	Go to Step 20	-
20	Record the low and the high side pressures and the instrument panel outlet air temperature after you perform the repairs. Compare the pressures and the instrument panel outlet air temperature to those listed in the A/C Performance Chart. Refer to Air Conditioning (A/C) System Performance Test (LY7) or Air Conditioning (A/C) System Performance Test (LZ4) or Air Conditioning (A/C) System Performance Test (LE5) or Air Conditioning (A/C) System Performance Test (LY7 Red Line) or Air Conditioning (A/C) System Performance Test (LAT Green Line) or Air Conditioning (A/C) System Performance Test (HP5) . Are the readings within the specified ranges as shown on the A/C Performance Chart?	Go to Step 21	Go to Air Conditioning (A/C) System Performance Test (LY7) or Air Conditioning (A/C) System Performance Test (LZ4) or Air Conditioning (A/C) System Performance Test (LE5) or Air Conditioning (A/C) System Performance Test (LY7 Red Line) or Air Conditioning (A/C) System Performance Test (LAT Green Line) or Air Conditioning (A/C) System Performance Test (HP5)
21	Operate the system in order to verify the repair. Did you find and correct the condition?	System OK	Go to Symptoms - HVAC Systems - Manual or Symptoms - HVAC Systems - Automatic .