Installation Procedure
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Add the specified amount of PAG oil to the condenser. Refer to Refrigerant System Capacities .
- Inspect the radiator to condenser seals for the proper position.
- Install the condenser by guiding the tabs into the retention clips on the radiator. Press down to engage the retention clips.
- Remove the protective cap from the compressor hose.
- Install a new sealing washer to the compressor hose. Refer to Sealing Washer Replacement .
- Install the compressor hose to the condenser.
- Install compressor hose nut to the condenser.
Tighten: Tighten the nut to 16 N.m (12 lb ft).
- Install a new seal washer to the receiver dehydrator. Refer to Sealing Washer Replacement .
- Install the receiver dehydrator to the condenser.
- Install the receiver dehydrator nut to the condenser.
Tighten: Tighten the nut to 16 N.m (12 lb ft).
- Install the CRFM closeout panel.
- For L61 vehicles, install the battery box air duct.
- Install the front fascia. Refer to Front Bumper Fascia Replacement (Redline) or Front Bumper Fascia Replacement (Standard) .
- Evacuate and charge the A/C system. Refer to Refrigerant Recovery and Recharging .
- Use J 39400-A to test the affected A/C joints leaks. See Special Tools .
NOTE:
Refer to Fastener Notice
.