LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1842 (Wheel Drive Shafts) >> Repair Instructions >> Front Wheel Drive Shaft Replacement (Hybrid) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing SA91112T On The Wheel Drive Shaft Oil Seal
    GM895295Courtesy of GENERAL MOTORS CORP.
  1. Install the SA91112T  seal protector. See Special Tools .
    2. Fig 2: Wheel Drive Shaft
    GM1825756Courtesy of GENERAL MOTORS CORP.
  2. Install the wheel drive shaft in the vehicle.
  3. Remove the SA91112T  seal protector. See Special Tools .
  4. Remove the J 2619-01  , the J 29794  , and the J 45341  . See Special Tools .
  5. Install the lower control arm to the knuckle. Refer to Lower Control Arm Replacement .
  6. Install the outer tie rod end for the steering gear to the knuckle. Refer to Rack and Pinion Outer Tie Rod End Replacement .
  7. Install the stabilizer link to the stabilizer bar. Refer to Stabilizer Shaft Link Replacement .
    8. Fig 3: View Of Wheel Drive Shaft Retaining Nut
    GM1825454Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  8. Install the NEW wheel drive shaft nut.

    Tighten:  Tighten the nut to 205 N.m (151 lb ft).

  9. Inspect the transmission fluid level and add fluid if necessary. Refer to Transmission Fluid Checking .
  10. Install the wheel house liner. Refer to Front Wheelhouse Liner Replacement .
  11. Install the tire and wheels. Refer to Lifting and Jacking the Vehicle .
  12. Lower the vehicle.
scientia non olet · About LEMON Manuals