LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1837 (Parking Brake System) >> Repair Instructions >> Park Brake Warning Lamp Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Warning Lamp Switch Mounting Screw & Electrical Connector
    GM891314Courtesy of GENERAL MOTORS CORP.
  1. Align the park brake warning lamp switch locating tab to the locating hole on the park brake lever assembly.
  2. Install the switch to the park brake lever.
    3. NOTE: Refer to Fastener Notice .
  3. Install the park brake warning lamp switch mounting screw (1).

    Tighten:  Tighten the screw to 4 N.m (35 lb in).

  4. Connect the park brake warning lamp switch electrical connector (2).
  5. Install the front floor console. Refer to Front Floor Console Replacement .
  6. Enable the SIR system. Refer to SIR Disabling and Enabling .
  7. Verify correct park brake warning lamp operation.
scientia non olet · About LEMON Manuals