LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1830 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Floor Shift Control Cable Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the shift control cable to the vehicle through the cowl and the carpet.
  2. Install the shift control cable grommet in the cowl.
    3. Fig 1: Control Cable & Control Assembly Lever
    GM1412174Courtesy of GENERAL MOTORS CORP.
  3. Install the shift control cable to the automatic transmission shift control.
  4. Install the left and right console trim panels. Refer to Front Floor Console Side Trim Panel Replacement - Left Side and Front Floor Console Side Trim Panel Replacement - Right Side .
    5. Fig 2: Disconnecting/Connecting Shift Control Cable At Range Select Lever & Bracket
    GM1547449Courtesy of GENERAL MOTORS CORP.
  5. Install the shift control cable and retaining clip (2) to the shift control cable bracket (1).
  6. Install the shift control cable (3) to the range select lever (4).
  7. Adjust the cable.
    1. Place the shift lever in N (Neutral). Rotate the selector shaft clockwise from P (Park) through R (Reverse) into N (Neutral).
    2. With the shift control assembly in N (Neutral) lift the cable connector locking clip up.
    3. Push the clip on the cable connector until fully seated and flush with cable body.
  8. If equipped with 2.4L (LAT), install the battery tray. Refer to Battery Tray Replacement (2.2L (L61)) or Battery Tray Replacement (2.4L (LAT)) or Battery Tray Replacement (3.5L (L66)) .
scientia non olet · About LEMON Manuals