LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1829 (Automatic Transmission - 5AT - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Shift Control Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: All shifter cable and park lock cable clips are one time usage only. Any service repair requiring cables to be disconnected from the transaxle control cable bracket or shiftier assembly will require a cable clip replacement.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Remove the right and left console trim panels. Refer to Front Floor Console Side Trim Panel Replacement - Right Side and Front Floor Console Side Trim Panel Replacement - Left Side .
    3. Fig 1: Shiftier Cable Retainer Clip, Cable & Control Assembly
    GM944208Courtesy of GENERAL MOTORS CORP.
  3. Using the J 36346  , disconnect the shifter cable from the control assembly pin.
  4. Remove the shifter cable retainer clip and remove the cable from the control assembly. Discard the clip.
    5. Fig 2: Park Lock Cable Assembly & Pin On Control Assembly
    GM944348Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the park lock cable assembly from the pin on the control assembly.
  6. Depress the tab on the park lock cable and remove the cable from the control assembly. Discard the park lock cable clip.
    7. Fig 3: Indicator Bulb
    GM945404Courtesy of GENERAL MOTORS CORP.
  7. Remove the indicator bulb by rotating the bulb a 1/4 turn and pulling out.
    8. Fig 4: Control Assembly Electrical Connectors
    GM944353Courtesy of GENERAL MOTORS CORP.
  8. Disconnect the control assembly electrical connectors.
    9. Fig 5: Control Assembly & Nuts
    GM944361Courtesy of GENERAL MOTORS CORP.
  9. Remove the nuts from the control assembly.
  10. Remove the control assembly and replace if necessary.
scientia non olet · About LEMON Manuals