Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .

Fig 1: View Of Stabilizer Shaft & Link

Courtesy of GENERAL MOTORS CORP.

Disconnect the stabilizer link from the stabilizer shaft.

Fig 2: Removing/Installing Steering Shaft To Intermediate Shaft

Courtesy of GENERAL MOTORS CORP.

Remove the lower intermediate steering shaft pinch bolt. Discard the bolt.
Disconnect the intermediate steering shaft from the steering gear.

Fig 3: View Of Tie Rod End To Steering Knuckle

Courtesy of GENERAL MOTORS CORP.

Disconnect the left outer tie rod from the steering knuckle. Refer to Rack and Pinion Outer Tie Rod End Replacement .

Fig 4: View Of Steering Gear & Steering Gear-To-Frame Bolts

Courtesy of GENERAL MOTORS CORP.

Remove the steering gear mounting bolts.
Secure the steering gear upward for clearance.

Fig 5: View Of Transaxle Mount And Mounting Bolts

Courtesy of GENERAL MOTORS CORP.

Remove the rear transmission mount. Refer to Transmission Rear Mount Replacement .

Fig 6: Rear Transmission Mount Bracket & Bolts

Courtesy of GENERAL MOTORS CORP.

If equipped with FWD, remove the rear transmission mount bracket to transmission bolts.

Fig 7: Removing Rear Powertrain Mount Bracket Bolts From The PTU

Courtesy of GENERAL MOTORS CORP.

If equipped with AWD, remove the rear transmission bracket to power takeoff bolts.
Remove the rear transmission mount bracket.