LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1822 (Wiring Systems And Power Management - Introduction) >> Repair Instructions >> Instrument Panel Electrical Center or Junction Block Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Record all preset radio stations.
  1. Turn the ignition OFF.
  2. Remove the screws from the battery cooling box. Remove the battery cover.
  3. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (2.2L (L61) and 3.5L (L66)) or Battery Negative Cable Disconnection and Connection (2.4L (LAT)) .
  4. Disconnect the positive battery cable.
  5. Remove the console. Refer to Front Floor Console Replacement .
    6. Fig 1: Removing/Installing Harness Connectors
    GM1232488Courtesy of GENERAL MOTORS CORP.
  6. Remove the nut holding the following fuse block connectors to the back of the I/P fuse block (4):
    • The body 68-way connector (1)
    • The I/P 68-way connector (2)
    • The I/P 24-way connector (3)
    7. Fig 2: Removing/Installing Fuse Block & Attaching Ground Wire & Bolt
    GM934747Courtesy of GENERAL MOTORS CORP.
  7. Remove the bolt holding the fuse block into place.
  8. Remove the ground wire (1).
  9. Remove the fuse block.
scientia non olet · About LEMON Manuals