LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1822 (Wiring Systems And Power Management - Introduction) >> Repair Instructions >> Ignition Lock Cylinder Case Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Remove the steering wheel. Refer to Steering Wheel Replacement .
  3. Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
  4. Remove the multifunction levers. Refer to Turn Signal Multifunction Switch Replacement .
    5. Fig 1: View Of Ignition Housing Electrical Connectors
    GM928832Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the housing electrical connectors.
    6. Fig 2: View Of Lock Housing Bolts
    GM928840Courtesy of GENERAL MOTORS CORP.
  6. Disengage the retaining tabs and remove the park lock cable assembly from the housing.
  7. Remove the lock housing bolts.
  8. Turn the ignition key to the ACC position.
    9. Fig 3: View Of Ignition Housing & Multi-Function Bracket
    GM931160Courtesy of GENERAL MOTORS CORP.
  9. Separate the lock housing (lock cylinder case) from the multifunction lever bracket. Slide the bracket from the column.
  10. Remove the ignition switch screws.
  11. Remove the ignition switch.
scientia non olet · About LEMON Manuals