LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1814 (Engine Mechanical - 2.2L (L61)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of RH Engine Mount
    GM928650Courtesy of GENERAL MOTORS CORP.
  1. Install the RH mount to the frame rail studs.
    2. NOTE: Refer to Fastener Notice .
  2. Install the RH mount to frame rail nuts.

    Tighten:  Tighten the nuts to 110 N.m (81 lb ft).

    3. Fig 2: Engine Mount & Mount Bracket Bolts
    GM928641Courtesy of GENERAL MOTORS CORP.
  3. Hand start the RH mount to bracket bolts.
    4. IMPORTANT: Powertrain mounts must be tightened in sequence.
  4. Balance the powertrain mounts. Refer to Powertrain Mount Balance - Total Mounts .
  5. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
scientia non olet · About LEMON Manuals