LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1814 (Engine Mechanical - 2.2L (L61)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Powertrain Mount Balance - Total Mounts

Powertrain Mount Balance - Total Mounts

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Follow the balance procedure in the order listed in the following steps. Powertrain mounts must be tightened in sequence.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. Fig 1: View Of Front Transaxle Mount Through Bolt
    GM928767Courtesy of GENERAL MOTORS CORP.
  2. Loosen the front mount through bolt. Do not remove.
    3. Fig 2: View Of Transaxle Mount And Mounting Bolts
    GM928736Courtesy of GENERAL MOTORS CORP.
  3. Loosen the rear mount through bolt. Do not remove.
  4. Position two floor jacks with wood blocks under the engine and transmission to support the powertrain assembly.
    5. Fig 3: Left Transmission Mount & Bolts
    GM928777Courtesy of GENERAL MOTORS CORP.
  5. From the engine compartment, loosen, do not remove the LH mount bolts.
    6. Fig 4: Engine Mount & Mount Bracket Bolts
    GM928641Courtesy of GENERAL MOTORS CORP.
  6. Loosen, do not remove the RH mount bolts.
  7. Reposition the floor jacks to allow a 1/8 inch gap between the mount and mount bracket
    8. Fig 5: Left Transmission Mount & Bolts
    GM928777Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  8. Tighten the LH mount starting with the center bolt.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

    9. Fig 6: Engine Mount & Mount Bracket Bolts
    GM928641Courtesy of GENERAL MOTORS CORP.
  9. Tighten the RH mount starting with the center bolt.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  10. Remove the floor jacks.
  11. Shake the powertrain vigorously from front to rear and allow the powertrain to settle.
    12. Fig 7: View Of Transaxle Mount And Mounting Bolts
    GM928736Courtesy of GENERAL MOTORS CORP.
  12. Tighten the rear mount through bolt.

    Tighten:  Tighten the bolts to 110 N.m (81 lb ft).

    13. Fig 8: View Of Front Transaxle Mount Through Bolt
    GM928767Courtesy of GENERAL MOTORS CORP.
  13. Tighten the front mount through bolt.

    Tighten:  Tighten the bolts to 110 N.m (81 lb ft).

  14. Lower the vehicle.
scientia non olet · About LEMON Manuals