Removal Procedure
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the windshield frame applique. Refer to Windshield Frame Applique Replacement .
- Remove the roof panel applique. Refer to Roof Front Panel Applique Replacement .
- Remove the windshield upper reveal molding (1).
- Using a angled pointed nose pliers, grip the center (2) section of the windshield upper reveal molding (1) at either end.
- Pull upward with a twist counterclockwise motion to start the removal of the windshield upper reveal molding (1).
This will start the disengagement of the molding from the windshield.
- Starting at the free end, pull the windshield upper reveal molding away from the windshield, a plastic tool may be needed to aid in the removal.
- Remove the windshield upper reveal molding and inspect the top edge of the windshield for any urethane adhesive or chip glass.
IMPORTANT: If the windshield was damaged while the removal of the windshield upper reveal molding the windshield must be replaced. Refer to Windshield Replacement . - Pull upward with a twist counterclockwise motion to start the removal of the windshield upper reveal molding (1).
IMPORTANT:
Both roof panel applique must be removed before starting this procedure to ensure proper repair.
To protect the windshield and paint during the removal and reinstall of the upper reveal molding, place a strip of 50 mm (2 in). masking tape below the upper reveal molding and across the top edge of the roof panel.
To protect the windshield and paint during the removal and reinstall of the upper reveal molding, place a strip of 50 mm (2 in). masking tape below the upper reveal molding and across the top edge of the roof panel.
IMPORTANT:
Do not allow any tool to come into contact with the windshield, tool contact with the windshield may cause cracks or fractures in the windshield.