LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1796 (Instrument Panel Trim And Console Trim) >> Repair Instructions >> Instrument Panel Upper Trim Panel Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to SIR Inflator Module Handling and Storage Caution .
    CAUTION: A deployed dual stage inflator module will look the same whether one or both stages were used, always assume a deployed dual stage inflator module has an active stage 2. Improper handling or servicing can activate the inflator module and cause personal injury.
    CAUTION: Refer to SIR Caution .
  1. Disable the frontal SIR system. Refer to SIR Disabling and Enabling .
  2. Remove the windshield garnish moldings. Refer to Windshield Upper Garnish Molding Replacement .
    3. Fig 1: View Of Knee Bolster (Filler Panel) & Screws
    GM939650Courtesy of GENERAL MOTORS CORP.
  3. Remove the screws from the steering column filler panel.
  4. Pull to remove the filler panel.
    5. Fig 2: Left I/P Outer Trim Cover
    GM987577Courtesy of GENERAL MOTORS CORP.
  5. Pull to remove the left I/P outer trim cover.
    6. Fig 3: Disconnecting/Connecting Electrical Connector
    GM987568Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the doorjamb switch electrical connector.
  7. Remove the right I/P outer trim cover. Refer to Instrument Panel Outer Trim Cover Replacement - Right Side .
    8. Fig 4: Removing Shift Level Bezel From The Console
    GM939672Courtesy of GENERAL MOTORS CORP.
  8. Beginning at the rearward edge, pull to remove the shift lever bezel from the console.
    9. Fig 5: Disconnecting/Connecting Electrical Connectors
    GM939700Courtesy of GENERAL MOTORS CORP.
  9. Disconnect the bezel electrical connectors.
    10. Fig 6: Removing/Installing Center Storage Compartment Screws
    GM933646Courtesy of GENERAL MOTORS CORP.
  10. Remove the center storage compartment screws.
  11. Remove the storage compartment.
  12. Remove the center trim bezel. Refer to Instrument Panel Accessory Bezel Replacement .
    13. Fig 7: Removing/Installing Screws From The Steering Column Shroud
    GM937241Courtesy of GENERAL MOTORS CORP.
  13. Using a small, flat-bladed tool, pry off the ignition bezel.
  14. Remove the screws from the steering column shroud.
  15. Remove the upper shroud.
  16. Remove the lower shroud.
    17. Fig 8: Removing/Installing Cluster Trim Panel Screws
    GM937097Courtesy of GENERAL MOTORS CORP.
  17. Remove the I/P cluster trim panel screw.
  18. Pull to remove the cluster trim.
    19. Fig 9: Removing/Installing Right Air Outlet Screw
    GM933607Courtesy of GENERAL MOTORS CORP.
  19. Remove the screw from the right air outlet.
  20. If equipped, remove the ambient light sensor. Refer to Ambient Light Sensor Replacement .
    21. Fig 10: Removing/Installing I/P Upper Trim Panel
    GM937278Courtesy of GENERAL MOTORS CORP.
  21. Using a small, flat-bladed tool, pry off the trim panel bolt covers.
  22. Remove the bolts from the I/P upper trim panel.
  23. Remove the screws from the I/P upper trim panel.
  24. Remove the I/P upper trim panel from the vehicle.
scientia non olet · About LEMON Manuals