Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installing Control Cable Bracket

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the control cable bracket and bolts.
Tighten: Tighten the control cable bracket bolts to 23 N.m (17 lb ft).
Route the control cable thru the cable bracket.

Fig 2: Control Cable Retainer Clip Tabs, Cable & Control Cable Bracket

Courtesy of GENERAL MOTORS CORP.

Secure the cable to the bracket with a new control cable retainer clip. An audible snap will be heard when properly installed.
Snap the cable end fitting onto the ball stud of the transaxle range switch lever.

Fig 3: View Of Battery Tray Bracket Bolts

Courtesy of GENERAL MOTORS CORP.

Install the battery tray bracket.
Position the battery tray bracket and install and tighten the screws.
Tighten: Tighten the battery tray bracket screws to 16 N.m (12 lb ft).
Install the battery cooling box. Refer to Battery Box Replacement installation procedure located in Battery.

Fig 4: View Of Battery

Courtesy of GENERAL MOTORS CORP.

Install the battery.
1. Insert the battery and tighten the battery hold-down screw.
  Tighten: Tighten the battery hold-down screw to 15 N.m (11 lb ft).
2. Connect the positive battery cable to the battery.
  Tighten: Tighten the positive battery cable bolts to 17 N.m (13 lb ft).
3. Connect the negative battery cable to the battery.
  Tighten: Tighten the negative battery cable bolts to 17 N.m (13 lb ft).
4. Install the battery cooling box cover and install and tighten the screws.
  Tighten: Tighten the battery cooling box cover screws to 2 N.m (1.5 lb ft).
Reprogram the radio stations.