Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Pushing Black Tab To Release End Fitting Using A Screwdriver

Courtesy of GENERAL MOTORS CORP.

Install a new end fitting on the park lock cable.

Fig 2: View Of Park Lock Cable Assembly & Ignition Module

Courtesy of GENERAL MOTORS CORP.

Snap the park lock cable assembly onto the ignition module.

Fig 3: Park Lock Cable Clip & Control Assembly

Courtesy of GENERAL MOTORS CORP.

Install the park lock cable onto the control assembly, using a new clip.

Fig 4: Park Lock Cable End Terminal & Control Assembly

Courtesy of GENERAL MOTORS CORP.

Install the park lock cable end terminal onto the control assembly by aligning the cable fitting to the pin and pushing forward. When installing, be sure not to install the cable end fitting on an angle or push down on the cable portion as this may cause cable to misadjust.

Fig 5: Lock Cylinder Bezel & Steering Column Shroud

Courtesy of GENERAL MOTORS CORP.

Verify the control assembly is in the P - Park position. Lock the adjuster piece into place by pushing in on the tab.

Fig 6: View Of Steering Column Upper & Lower Shrouds Panels

Courtesy of GENERAL MOTORS CORP.

Install the shroud fasteners and install the steering column upper and lower shroud panels.
Install the lock cylinder bezel onto the steering column shroud.
Perform the operation inspection. Refer to Park Lock Cable Replacement procedure in this section.
Install the console. Refer to Console Replacement procedure in Body and Accessories.
Enable the SIR system. Refer to DISABLING SYSTEM .