LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1745 (Automatic Transaxle - AF33-5 (Removal & Installation, Service & Overhaul)) >> Repair Instructions >> Oil Cooler Line Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Ensure that the vehicle is properly supported and squarely positioned. To help avoid personal injury when a vehicle is on a hoist, provide additional support for the vehicle on the opposite end from which the components are being removed.
  1. Place a drain pan or suitable container under the vehicle.
  2. Position the vehicle on a hoist.
    3. Fig 1: View Of Transaxle Oil Cooler Lines
    GM945432Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the transaxle oil cooler lines from the radiator.
  4. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    5. Fig 2: View Of Transaxle Oil Cooler Lines
    GM945444Courtesy of GENERAL MOTORS CORP.
  5. Remove the transaxle cooler line assembly nut from the transaxle.
  6. Remove the transaxle cooler lines from the vehicle.
  7. Replace the transaxle oil cooler pipe seals. Refer to the Oil Cooler Pipe Seals Replacement  procedure located in this manual.
scientia non olet · About LEMON Manuals