LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1745 (Automatic Transaxle - AF33-5 (Removal & Installation, Service & Overhaul)) >> Repair Instructions >> Input Shaft Speed Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply automatic transaxle fluid to the new input speed sensor O-ring.
  2. Install the new input speed sensor O-ring onto the input speed sensor.
  3. Install the input speed sensor onto the transaxle case assembly.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the input speed sensor bolt.

    Tighten:  Tighten the input speed sensor bolt to 6 N.m (53 lb in).

  5. Connect the wiring harness to the input speed sensor.
    6. Fig 1: View Of Battery Tray Bracket Bolts
    GM951487Courtesy of GENERAL MOTORS CORP.
  6. Install the battery tray bracket.

    Tighten:  Tighten the battery tray bracket screws to 16 N.m (12 lb-ft)

  7. Install the battery cooling box. Refer to the Battery Cooling Box installation procedure located in this service manual.
scientia non olet · About LEMON Manuals