LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1745 (Automatic Transaxle - AF33-5 (Removal & Installation, Service & Overhaul)) >> Repair Instructions >> Control Valve Body Cover Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Control Valve Body Cover
    GM749819Courtesy of GENERAL MOTORS CORP.
  1. Clean any gasket material from the control valve body cover and inspect the gasket mounting surface.
  2. Install RTV sealer Saturn P/N 89020326 onto the control valve body cover.
    3. Fig 2: View Of Control Valve Body Cover
    GM959429Courtesy of GENERAL MOTORS CORP.
  3. Install the control valve body cover onto the transaxle case.
    4. IMPORTANT: Use LOCTITE™ 242 thread sealer on ALL bolt threads.
  4. Install the 9 control valve body cover bolts/screws hand tight.
    5. Fig 3: Installing Control Valve Body Bolts/Screws
    GM749335Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  5. Tighten the 9 control valve body bolts/screws in the sequence shown.

    Tighten:  Tighten the control valve body cover bolts/screws to 13 N.m (10 lb in).

    6. Fig 4: View Of Transaxle Oil Cooler Lines
    GM945444Courtesy of GENERAL MOTORS CORP.
  6. Install the transaxle oil cooler line assembly to the transaxle.
  7. Install the transaxle oil cooler line assembly nut.

    Tighten:  Tighten the transaxle oil cooler line nut to 7 N.m (62 lb in)

    8. Fig 5: View Of Front Pitch Restrictor Through-Bolt
    GM993567Courtesy of GENERAL MOTORS CORP.
  8. Install the front pitch restrictor and the through-bolt.

    Tighten:  Tighten the front pitch restrictor bolts to 50 N.m (37 ft lb)

    9. Fig 6: View of Engine Splash Shield
    GM929650Courtesy of GENERAL MOTORS CORP.
  9. Install the left-hand splash shield.
  10. Install the left wheel and the tire assembly.
  11. Install the wheel nuts and tighten in a criss-cross pattern.

    Tighten:  Tighten the wheel nuts to 125 N.m (92 lb-ft)

  12. Lower the vehicle.
    13. NOTE: Saturn automatic transaxle fluid (ATF), P/N 21005966 and P/N 21019223, is not compatible with this transaxle. If Saturn ATF is used, transaxle damage will result. This transaxle uses Saturn T-IV fluid P/N 22689186.
  13. Add fluid to the transaxle. Refer to Transmission Fluid Replacement  procedure located in this service manual.
scientia non olet · About LEMON Manuals