Diagnostic Aids
WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- The low or highbeam headlamps must be on in order to set this DTC.
- An open PARK LP fuse will set this code.
- If the DTC is a history DTC, the problem may be intermittent. Refer to Testing for Intermittent Conditions and Poor Connections in Wiring Systems.
DTC B2662
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Exterior Lights Schematics | |||
| 1 | Did you perform the Lighting System Diagnostic System Check? | Go to Step 2 | Go to Diagnostic System Check - Lighting Systems |
| 2 |
|
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
| 3 | Are the park lamps operating properly when the headlamp switch is turned ON and then OFF? | Go to Step 4 | Go to Step 6 |
| 4 | Test the signal circuit of the headlamp switch for an open or high resistance. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 11 | Go to Step 5 |
| 5 | Inspect for poor connections at the harness connector of the BCM. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 11 | Go to Step 9 |
| 6 | Test the battery positive voltage circuit of the headlamp switch for an open or short to ground. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 11 | Go to Step 7 |
| 7 | Test the park lamp signal circuit of the headlamp switch for an open or high resistance. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 11 | Go to Step 8 |
| 8 | Inspect for poor connections at the harness connector of the headlamp switch. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 11 | Go to Step 10 |
| 9 |
IMPORTANT:
Perform the set up procedure for the body control module. Refer to Body Control Module (BCM) Programming/RPO Configuration
in Body Control System. Replace the body control module. Refer to Body Control Module Replacement
in Body Control System.Did you complete the replacement? |
Go to Step 11 | - |
| 10 | Replace the headlamp switch. Refer to Multifunction, Turn Signal Switch Replacement
in Steering Wheel and Column. Did you complete the replacement? |
Go to Step 11 | - |
| 11 |
|
Go to Step 2 | System OK |