LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1675 (Engine Mechanical - 3.1L V6 - VIN (J)) >> Repair Instructions >> On-Vehicle repair Instructions >> Engine Mount Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground (negative) cable. Refer to BATTERY NEGATIVE CABLE DISCONNECT/CONNECT PROCEDURE Battery.
  2. Remove the throttle body air inlet duct.
  3. Remove the engine mount struts. Refer to ENGINE MOUNT STRUT REPLACEMENT  .
  4. Raise and suitably support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
  5. Remove the three-way catalytic converter pipe from the right (rear) exhaust manifold. Refer to CATALYTIC CONVERTER REPLACEMENT (3.1L) in Engine Exhaust.
  6. Remove the right front wheel and tire. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in Tires and Wheels.
  7. Remove the right engine splash shield. Refer to SPLASH SHIELD REPLACEMENT - ENGINE in Body Front End.
  8. Remove the engine mount lower nuts.
    Fig 1: Removing Engine Mount Lower Nuts
    G01967816Courtesy of GENERAL MOTORS CORP.
  9. Raise the engine, using the engine support fixture. Refer to ENGINE SUPPORT FIXTURE  .
  10. Remove the engine mount bracket-to-oil pan bolts.
  11. Remove the engine mount and the engine mount bracket.
    Fig 2: Removing Engine Mount, Engine Mount Bracket & Mounting Bolts
    G01967817Courtesy of GENERAL MOTORS CORP.
  12. Remove the engine mount bracket. Refer to ENGINE MOUNT BRACKET REPLACEMENT  .
    Fig 3: Removing Engine Mount Bracket
    G01967818Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals