LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1655 (Cellular Communication System) >> Repair Instructions >> Coaxial Cable Replacement - Cellular Telephone >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Cadillac Escalade EXT. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the headliner. Refer to HEADLINER REPLACEMENT .
  2. Remove the IP trim panel. Refer to TRIM PANEL REPLACEMENT - INSTRUMENT PANEL (I/P) UPPER .
  3. Remove the driver's side door sill plate. Refer to DOOR SILL PLATE REPLACEMENT - FRONT .
  4. Remove the hinge pillar trim moldings. Refer to TRIM PANEL REPLACEMENT - HINGE PILLAR .
  5. Disconnect the cable connector from the antenna inner coupling (1).
  6. Remove the cable clips (2) from the roof and pillar.
    7. Fig 1: Cable Clips
    GM798120Courtesy of GENERAL MOTORS CORP.
  7. Remove the cable from the body harness conduit (1).
    Fig 2: Body Harness Conduit
    GM798122Courtesy of GENERAL MOTORS CORP.
  8. Remove the cable clips (2) from underneath the IP.
    Fig 3: Cable Connector
    GM798124Courtesy of GENERAL MOTORS CORP.
  9. Disconnect the cable connector (3) from the VCU.
  10. Attach a wire to the end of the cable connector (3) in order for the coaxial cable to be pulled from underneath the IP.
  11. Remove the wire from the coaxial cable.
  12. Remove the cable from the vehicle.
scientia non olet · About LEMON Manuals