LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Diagnostic Information and Procedures >> DTC B1735, B1740, B1745, B1750, B1755, B1760, B1815, or B1820 >> Diagnostic Aids

Diagnostic Aids

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

If the DTC is only found in history, the fault may be intermittent. Refer to TESTING FOR INTERMITTENT CONDITIONS AND POOR CONNECTIONS in Wiring Systems.

DTC B1735, B1740, B1745, B1750, B1755, B1760, B1815, or B1820

Step Action Yes No
Schematic Reference:  Power Seats Schematics  
Connector End View Reference:  Power Seat Systems Connector End Views  
1 Did you perform the Power Seat Diagnostic System Check? Go to Step 2  Go to Diagnostic System Check - Power Seat Systems 
2
  1. Install a scan tool.
  2. Observe the switch parameter for which the DTC has set in the seat module Inputs/Outputs data list.
Does the scan tool display Inactive?
Go to TESTING FOR INTERMITTENT CONDITIONS AND POOR CONNECTIONS in Wiring Systems Go to Step 3 
3 Disconnect the seat adjuster switch connector.
Does the scan tool display Inactive?
Go to Step 5  Go to Step 4 
4 Test the switch signal circuit for which the DTC has set for a short to voltage. Refer to CIRCUIT TESTING and WIRING REPAIRS in Wiring Systems.
Did you find and correct the condition?
Go to Step 9  Go to Step 7 
5 Inspect for poor connections at the seat adjuster switch. Refer to TESTING FOR INTERMITTENT CONDITIONS AND POOR CONNECTIONS and CONNECTOR REPAIRS in Wiring Systems.
Did you find and correct the condition?
Go to Step 9  Go to Step 6 
6 Replace the seat adjuster switch. Refer to Seat Switch Replacement - Power .
Is the repair complete?
Go to Step 9  -
7 Inspect for poor connections at the seat module. Refer to TESTING FOR INTERMITTENT CONDITIONS AND POOR CONNECTIONS and CONNECTOR REPAIRS in Wiring Systems.
Did you find and correct the condition?
Go to Step 9  Go to Step 8 
8 Replace the seat module. Refer to Memory Seat Control Module Replacement .
Is the repair complete?
Go to Step 9  -
9
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.
Does the DTC reset?
Go to Step 2  System OK