Engine Oil Temperature Gage Inoperative
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
Engine Oil Temperature Gage Inoperative
| Step | Action | Values | Yes | No |
|---|---|---|---|---|
| Schematic Reference: Instrument Cluster Schematics | ||||
| 1 | Did you perform the IPC Diagnostic System Check? | - | Go to Step 2 | Go to Diagnostic System Check - Instrument Cluster |
| 2 | With a scan tool, observe the Oil Temp parameter in the IPC data 1 list. Does the scan tool indicate the correct oil temperature? |
- | Go to Step 3 | Go to Step 4 |
| 3 | With a scan tool, observe the Oil Temp parameter in the IPC data 1 list and the oil temperature gage display on the DIC. Does the scan tool display correspond with the oil temperature gage display within the specified value? |
10°C (14°F) |
System OK | Go to Step 5 |
| 4 | Replace the oil temperature sensor. Refer to Engine Oil Temperature Gage Sensor Replacement
. Did you complete the replacement? |
- | Go to Step 6 | - |
| 5 | Replace the IPC. Refer to Instrument Panel Cluster (IPC) Replacement . Did you complete the replacement? |
- | Go to Step 6 | - |
| 6 | Operate the system in order to verify the repair. Did you correct the condition? |
- | System OK | Go to Step 2 |