LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1466 (Automatic Transmission, 4L60-E/4L65-E Diagnosis (DTC P0218 To DTC P0748 - 4.2L)) >> Diagnostic Information and Procedures >> DTC P0218 (4.2L) >> Test Description

Test Description

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

The numbers below refer to the step numbers on the diagnostic table.

  1. 3:  This step inspects for air flow restrictions or damage which may result from the transmission overheating.
DTC P0218 (4.2L)

Step Action Value(s) Yes No
1 Did you perform the Diagnostic System Check - Engine Controls? - Go to Step 2  Go to Diagnostic System Check - Engine Controls in Engine Controls-4.2L
2
  1. Install a scan tool.
  2. Turn ON the ignition, with the engine OFF.
    3. IMPORTANT: Before clearing the DTC, use the scan tool in order to record the Failure Records. Using the Clear Info function erases the Failure Records from the PCM.
  3. Record the DTC Failure Records.
  4. Clear the DTC.
  5. Inspect for correct transmission fluid level. Refer to Transmission Fluid Checking Procedure .
Did you perform the fluid checking procedure?		 - Go to Step 3  Go to Transmission Fluid Checking Procedure
3 
  1. Inspect the engine cooling system and transmission cooling system for the following conditions:
    • Air flow restrictions
    • Air flow blockage
    • Debris
  2. Inspect the transmission cooling system for damaged cooler lines.
  3. Test the oil cooler flow.

    Refer to Automatic Transmission Oil Cooler Flushing and Flow Test (J 45096) or Automatic Transmission Oil Cooler Flushing and Flow Test (J 35944-A) .

Did you find and correct the condition?		 - Go to Step 6  Go to Step 4 
4 Test for correct line pressure.
Refer to Line Pressure Check Procedure .
Did you find and correct the condition?		 - Go to Step 6  Go to Step 5 
5 Test the torque converter stator.
Refer to Torque Converter Diagnosis Procedure .
Did you find and correct the condition?		 - Go to Step 6  Go to Intermittent Conditions in Engine Controls - 4.2L
6 Perform the following procedure in order to verify the repair:
  1. Install a scan tool.
  2. Select DTC.
  3. Select Clear Info.
  4. Start and idle the engine until it reaches normal operating temperature.
  5. Monitor Engine Run Time and Trans. Fluid Temp. on the scan tool.
  6. Drive the vehicle for 10 minutes.
  7. Ensure that the transmission fluid temperature has stabilized and is less than 129° C (264° F).
  8. Select Specific DTC.
  9. Enter DTC P0218.

Has the test run and passed?		 - Go to Step 7  Go to Step 2 
7 With the scan tool, observe the stored information, capture info, and DTC Info.
Does the scan tool display any DTCs that you have not diagnosed?		 - Go to Diagnostic Trouble Code (DTC) List in Engine Controls - 4.2L System OK
scientia non olet · About LEMON Manuals