LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1449 (Automatic Transmission - 4L60-E/4L65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Transmission Extension Housing Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Case Extension, Bolts & O-Ring Seal
    GM656358Courtesy of GENERAL MOTORS CORP.
  1. Install a new case extension O ring seal (3).
  2. Install the case extension (2).
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the case extension bolts (1).

    Tighten:  Tighten the case extension bolts (1) to 45 N.m (33 lb ft).

  4. Install the transmission mount. Refer to Transmission Mount Replacement (4.2L)  or Transmission Mount Replacement (5.3L)  .
  5. Install the propeller shaft. Refer toPropeller Shaft Replacement - Rear in Propeller Shaft.
  6. Remove the drain pan and the transmission jack.
  7. Lower the vehicle.
  8. Fill the transmission to the proper level with DEXRON® III transmission fluid. Refer to Transmission Fluid Checking Procedure .
scientia non olet · About LEMON Manuals