LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1449 (Automatic Transmission - 4L60-E/4L65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Filler Tube and Seal Replacement (LM4) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Level Indicator Tube & Seal
    GM396798Courtesy of GENERAL MOTORS CORP.
  1. Install a NEW seal to the indicator tube.
  2. Install the oil level indicator tube.
    3. Fig 2: View Of Oil Level Indicator Tube Nut
    GM396797Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the indicator tube nut.

    Tighten:  Tighten the nut to 18 N.m (13 lb ft).

  4. Install the catalytic converter. Refer to Catalytic Converter Replacement (4.2L Engine) or Catalytic Converter Replacement (5.3L Engine)
  5. Install the transmission crossmember. Refer to Transmission Support Replacement in Frame and Underbody.
  6. Remove the support from the transmission.
  7. Lower the vehicle.
  8. Install the transmission oil level indicator.
  9. Fill the transmission to the proper level with DEXRON® III transmission fluid. Refer to Transmission Fluid Checking Procedure .
scientia non olet · About LEMON Manuals