LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1449 (Automatic Transmission - 4L60-E/4L65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Filler Tube and Seal Replacement (LL8) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Filler Tube & Seal (LL8)
    GM744703Courtesy of GENERAL MOTORS CORP.
  1. Install a new seal (2) into the transmission case.
  2. Install the filler tube (1) into the seal.
  3. Remove the drain pan.
  4. Lower the vehicle.
    5. Fig 2: View Of Filler Tube, Nut & Stud (LL8)
    GM744648Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the nut (2) securing the filler tube to the secondary AIR stud (1).

    Tighten:  Tighten the nut to 10 N.m (89 lb in).

  6. Install the filler tube indicator.
  7. Fill the transmission to the proper level with DEXRON® III transmission fluid. Refer to Transmission Fluid Checking Procedure .
scientia non olet · About LEMON Manuals