LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1449 (Automatic Transmission - 4L60-E/4L65-E (Introduction, Service & Replacement)) >> Repair Instructions >> 2-4 Servo >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install new seals on the servo pistons and the servo cover.
    2. Fig 1: View Of 2-4 Servo
    GM642523Courtesy of GENERAL MOTORS CORP.
  2. Install the 2-4 servo assembly into the transmission.
  3. Install the J 29714-A  . See Special Tools and Equipment .
    4. Fig 2: Compressing The Servo Cover Using J 29714-A
    GM14478Courtesy of GENERAL MOTORS CORP.
  4. Tighten the bolt in order to compress the servo cover.
  5. Install the servo cover retaining ring.
  6. Remove the J 29714-A  from the oil pan flange. See Special Tools and Equipment .
    7. NOTE: Refer to Fastener Notice in Cautions and Notices.
  7. Install the transmission oil pan bolt.

    Tighten:  Tighten the bolt to 11 N.m (97 lb in).

  8. Install the heat shield if equipped. Refer to Heat Shield Replacement  .
  9. Install the exhaust pipe assembly. Refer to Catalytic Converter Replacement (4.2L Engine) or Catalytic Converter Replacement (5.3L Engine) in Engine Exhaust.
  10. Install the transmission support. Refer to Transmission Support Replacement in Frame and Underbody.
  11. Remove the transmission jack.
  12. Lower the vehicle.
  13. Fill the transmission to the proper level with DEXRON® III transmission fluid. Refer to Transmission Fluid Checking Procedure .
scientia non olet · About LEMON Manuals