LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1418 (HVAC Systems - Automatic) >> Repair Instructions >> Air Temperature Actuator Replacement - Auxiliary >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Air Temperature Actuator From Rear HVAC Module
    GM814583Courtesy of GENERAL MOTORS CORP.
  1. Install the air temperature actuator (2) to the rear HVAC module.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the screws to the actuator.

    Tighten:  Tighten the screws to 1.9 N.m (17 lb in).

  3. Connect the electrical connector to the air temperature actuator.
  4. Recalibrate the air temperature actuator. Refer to Re-Calibrating Actuators (Primary)  or Re-Calibrating Actuators (Auxiliary HVAC) .
  5. Install the right rear quarter trim panel. Refer to Trim Panel Replacement - Rear Quarter - Right (TrailBlazer, Envoy, Bravada) or Trim Panel Replacement - Rear Quarter - Right (TrailBlazer EXT, Envoy XL) in Interior Trim.
scientia non olet · About LEMON Manuals