Backup Lamps Always On
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
Backup Lamps Always On Diagnostic Test
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Exterior Lights Schematics Connector End View Reference: Lighting Systems Connector End Views or Body Control System Connector End Views in Body Control System |
|||
| 1 | Did you perform the Lighting Systems Diagnostic System Check? | Go to Step 2 | Go to Diagnostic System Check - Lighting Systems |
| 2 | Verify that the backup lamps are always on. Do the backup lamps operate normally? |
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
| 3 | Use the scan tool to check if there are any codes set in the current or history Powertrain DTC Information. Are any codes present? |
Go to Diagnostic System Check - Automatic Transmission in Automatic Transmission - 4L60-E/4L65-E | Go to Step 4 |
| 4 | Inspect for poor connections at the harness connector of the Body Control Module (BCM). Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 6 | Go to Step 5 |
| 5 |
IMPORTANT:
Perform the setup procedure for the BCM. Replace the body control module (BCM). Refer to Body Control Module Replacement
in Body Control System.Did you complete the replacement? |
Go to Step 6 | - |
| 6 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 3 |