LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1362 (Parking Brake System) >> Repair Instructions >> Park Brake Shoe Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear disc. Refer to Brake Rotor Replacement - Rear in Disc Brakes.
    2. Fig 1: Removing/Installing Return Springs
    GM818026Courtesy of GENERAL MOTORS CORP.
  2. Remove the return springs (1,2).
    3. Fig 2: Removing/Installing Tension Spring
    GM818033Courtesy of GENERAL MOTORS CORP.
  3. Remove the tension spring (1).
    4. Fig 3: Park Brake Components
    GM817998Courtesy of GENERAL MOTORS CORP.
  4. Separate the adjuster (15) from the front brake shoe (17).
  5. Remove the hold-down spring (16) and the pin (1) from the front shoe.
  6. Remove the front shoe.
  7. Separate the adjuster from the rear brake shoe (8).
  8. Remove the adjuster and the adjuster strut (7).
  9. Disassemble the adjuster (10,11,15)
  10. Remove the hold-down spring (9) and the pin (2) from the rear shoe.
  11. Separate the rear shoe from the park brake shoe lever (6).
  12. Remove the rear shoe.
    13. Fig 4: Removing/Installing Park Brake Shoe Lever And Park Brake Cable
    GM818046Courtesy of GENERAL MOTORS CORP.
  13. Remove the park brake shoe lever (2) from the park brake cable (1).
  14. Inspect the park brake hardware. Refer to Park Brake Hardware Inspection (Drum Brakes)  or Park Brake Hardware Inspection (Disc Brakes) .
scientia non olet · About LEMON Manuals