LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1351 (Antilock Brake System) >> Diagnostic Information and Procedures >> DTC C0000 >> Test Description

Test Description

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

The number below refers to the step number on the diagnostic table.

  1. 2:  This step determines if the correct EBCM is installed.
DTC C0000

Step Action Yes No
Schematic Reference:  ABS Schematics  
Connector End View Reference:  ABS Connector End Views  
1 Did you perform A Diagnostic System Check - ABS? Go to Step 2  Go to Diagnostic System Check - ABS 
2  Verify the correct EBCM is installed.
Is the correct EBCM is installed?		 Go to Step 4  Go to Step 3 
3 Replace the brake pressure modulator valve (BPMV). Refer to Brake Modulator Assembly Replacement .
Did you complete the replacement?		 Go to Step 4  -
4
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.
Does the DTC reset?		 Go to Step 2  System OK
scientia non olet · About LEMON Manuals