LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1344 (Wiper System & Washer System) >> Diagnostic Information and Procedures >> Wipers Inoperative - One Mode

Wipers Inoperative - One Mode

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
Wipers Inoperative - One Mode

Step Action Yes No
Schematic Reference: Wiper/Washer System Schematics 
Connector End View Reference: Wiper/Washer System Connector End Views 
1 Did you review the Wiper/Washer System Description and Operation  and perform the necessary inspections? Go to Step 2  Go to Diagnostic Starting Point - Wiper/Washer Systems 
2
  1. Turn the ignition ON, engine OFF.
  2. Turn the wiper switch to the LO, HI, and INT positions.
Do the front wipers operate in the LO, HI, and INT positions?		 Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems Go to Step 3 
3 Do the wipers operate in the LO and HI position, but not the INT position? Go to Step 6  Go to Step 4 
4
  1. Disconnect the wiper motor.
  2. Turn the ignition ON, engine OFF.
  3. Turn the wiper switch to the affected speed.
  4. With a test lamp connected to a good ground, test the corresponding voltage supply circuit at the wiper motor connector for ignition positive voltage.
Does the test lamp illuminate?		 Go to Step 7  Go to Step 5 
5
  1. Turn the wiper switch to the affected speed.
  2. With a test lamp connected to a good ground, test the corresponding voltage supply circuit at the wiper/washer switch for ignition positive voltage.
Does the test lamp illuminate?		 Go to Step 8  Go to Step 6 
6 Inspect for poor connections at the harness connector of the wiper/washer switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 11  Go to Step 9 
7 Inspect for poor connections at the harness connector of the wiper motor. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 11  Go to Step 10 
8 Repair the high resistance or open condition in the voltage supply circuit to the wiper motor. Refer to Wiring Repairs in Wiring Systems.
Did you complete the repair?		 Go to Step 11  -
9 Replace the front wiper/washer switch. Refer to Wipers/Washer Switch Replacement .
Did you complete the replacement?		 Go to Step 11  -
10 Replace the front wiper motor. Refer to Wiper Motor Replacement .
Did you complete the replacement?		 Go to Step 11  -
11 Operate the system in order to verify the repair.
Did you correct the condition?		 System OK Go to Step 3 
scientia non olet · About LEMON Manuals