Power Window Inoperative - Passenger Door

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Step	Action	Yes	No
Schematic Reference: Power Window Schematics Connector End View Reference: Power Door Systems Connector End Views
1	Did you review the Power Windows Description and Operation?	Go to Step 2	Go to Symptoms - Doors
2	Verify that the inoperative passenger door power window fault is present. Do the passenger door power windows operate normally?	Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems	Go to Step 3
3	Disconnect the appropriate passenger window switch. Turn ON the ignition, with the engine OFF. Probe the power window voltage supply circuit of the appropriate passenger window switch with a test lamp that is connected to a good ground. Does the test lamp illuminate?	Go to Step 4	Go to Step 6
4	Connect a test lamp between the power window master switch up signal circuit of the appropriate passenger window switch and the power window master switch down signal circuit of the appropriate passenger window switch. Activate the driver window switch to the UP and DOWN positions. Does the test lamp illuminate?	Go to Step 5	Go to Step 7
5	Connect the appropriate passenger window switch. Disconnect the appropriate passenger window motor. Connect a test lamp between the power window motor up control circuit of the appropriate passenger window motor and the power window motor down control circuit of the appropriate passenger window motor. Activate the appropriate passenger window switch to the UP and DOWN positions. Does the test lamp illuminate?	Go to Step 9	Go to Step 8
6	Test the power window voltage supply circuit of the appropriate passenger window switch for an open or short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 15	Go to Step 10
7	Test the power window master switch signal circuits of the appropriate passenger window switch for a short to voltage or an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 15	Go to Step 10
8	Test the power window motor circuits of the appropriate passenger window motor for a short to voltage or an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 15	Go to Step 11
9	Inspect for poor connections at the appropriate passenger window motor. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 15	Go to Step 12
10	Inspect for poor connections at the driver window switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 15	Go to Step 13
11	Inspect for poor connections at the appropriate passenger window switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 15	Go to Step 14
12	Replace the appropriate passenger window motor. Refer to Window Regulator Replacement - Front Door or Window Regulator Replacement - Rear Door . Did you complete the replacement?	Go to Step 15	-
13	Replace the driver window switch. Refer to Power Window Switch Replacement . Did you complete the replacement?	Go to Step 15	-
14	Replace the appropriate passenger window switch. Refer to Power Window Switch Replacement . Did you complete the replacement?	Go to Step 15	-
15	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 2