Audio Distortion - One or More Speakers
WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
Audio Distortion - One or More Speakers
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Radio/Audio System Schematics DEFINITION: This table is used for vehicles equipped with a radio amplifier. |
|||
| 1 | Did you perform the Radio/Audio System Diagnostic System Check? | Go to Step 2 | Go to Diagnostic System Check - Radio/Audio System |
| 2 |
|
Go to Step 3 | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems |
| 3 | Test the appropriate radio speaker output circuits between the radio and the radio amplifier for an open or high resistance. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 6 | Go to Step 4 |
| 4 | Inspect for poor connections at the harness connector of the appropriate speaker. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 6 | Go to Step 5 |
| 5 | Replace the speaker. Refer to Speaker Replacement - Rear or to Speaker Replacement - Front Lower . Did you complete the replacement? |
Go to Step 6 | - |
| 6 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |