Instrument Cluster Inoperative
WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
Instrument Cluster Inoperative
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Instrument Cluster Schematics | |||
| 1 | Did you review the Instrument Panel Cluster Description and Operation and perform the necessary inspections? | Go to Step 2 | Go to Symptoms - Instrument Panel, Gages and Console |
| 2 | Verify that the instrument cluster is inoperative. Does the system operate normally? |
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
| 3 | Inspect the following indicators:
Are the inspected indicators inoperative? |
Go to Step 4 | Go to Step 6 |
| 4 | Test the WHT/BLK between the instrument cluster connector C2 cavity 12 and G204 for an open. Is an open condition present? |
Go to Step 5 | Go to Step 11 |
| 5 | Repair the open in the WHT/BLK wire between the instrument cluster connector C2 cavity 12 and G204. Refer to Wiring Repairs
in Wiring Systems. Is the repair complete? |
Go to Step 13 | - |
| 6 | Inspect the following indicators:
Are the inspected indicators inoperative? |
Go to Step 7 | Go to Step 8 |
| 7 |
|
Go to Step 8 | Go to Step 9 |
| 8 | Replace the instrument cluster assembly printed circuit. Refer to Instrument Panel Cluster (IPC) Replacement . Is the repair complete? |
Go to Step 13 | - |
| 9 | Test the battery positive voltage circuit between junction block 3 connector C2 and the instrument cluster assembly C1 cavity 2 for an open. Is an open condition present? |
Go to Step 10 | Go to Step 8 |
| 10 | Repair the open in the battery positive voltage circuit. Refer to Wiring Repairs
in Wiring Systems. Is the repair complete? |
Go to Step 13 | - |
| 11 | Check connector C2 for damage. Is the connector damaged? |
Go to Step 12 | Go to Step 8 |
| 12 | Repair the connector. Refer to Connector Repairs
in Wiring Systems. Is the repair complete? |
Go to Step 13 | - |
| 13 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 3 |