Gages Inoperative - All
WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
Gages Inoperative - All
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Instrument Cluster Schematics | |||
| 1 | Did you review the Instrument Panel, Gages and Console Description and Operation and perform the necessary inspections? | Go to Step 2 | Go to Symptoms - Instrument Panel, Gages and Console |
| 2 | Verify that the instrument cluster gages are inoperative. Does the system operate normally? |
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
| 3 |
|
Go to Step 4 | Go to Step 5 |
| 4 | Repair the open in the WHT/BLK wire between the instrument cluster and G200 Refer to Wiring Repairs in Wiring Systems. Did you complete the repair? |
Go to Step 8 | - |
| 5 | With connector still disconnected. Test terminal 1 for open or short to ground Refer to Circuit Testing in Wiring Systems. Is open or short present? |
Go to Step 6 | Go to Step 7 |
| 6 | Repair open or short to ground Refer to Wiring Repairs in Wiring Systems Did you repair short or open? |
Go to Step 8 | - |
| 7 | Replace the Instrument Cluster Refer to Instrument Panel Cluster (IPC) Replacement Did you complete the replacement? |
Go to Step 8 | - |
| 8 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 3 |