LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1316 (Transfer Case - NVG 246-NP8 (Two Speed Automatic)) >> Repair Instructions >> Transfer Case Shift Control Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Transfer Case Driver Control Switch
    GM396838Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Make sure that the transfer case control switch is seated properly in the instrument panel before installing the instrument panel trim bezel.
  1. Install the transfer case driver control switch into the instrument panel.
    2. Fig 2: Identifying Transmission Mount Nuts
    GM348730Courtesy of GENERAL MOTORS CORP.
  2. Install the instrument panel trim bezel. Refer to BEZEL REPLACEMENT - IP CLUSTER in Instrument Panel, Gages, and Console.
scientia non olet · About LEMON Manuals