Tool Required

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.

J 41790 Compressor Holding Fixture

Clean the pressure relief valve seat area of the rear head.
Lubricate the O-ring of the new pressure relief valve with clean 525 viscosity refrigerant oil.
NOTE: Refer to FASTENER NOTICE .
Install the new pressure relief valve into the compressor.
Tighten

Tighten the pressure relief valve to 9 N.m (80 lb in).
Remove the compressor from the J 41790 .

Fig 1: Installing Pressure Relief Valve Into Compressor (V5 - Direct Mount)

Courtesy of GENERAL MOTORS CORP.